1st Gen A/C Compressor - Manifold O-Rings

Use this forum to discuss audio and electronic upgrades for your Isuzu

Moderator: Staff

1st Gen A/C Compressor - Manifold O-Rings

Postby furiousbob » Tue Mar 21, 2017 9:31 pm

I'm working on replacing the O-rings where the suction/discharge lines on the rear of the compressor connect. I'm a bit stumped. I ordered new rings from Rockauto and I have:

Original o-rings (they don't look too bad, tbh):

Image

New rings:

Image

Where they mate:

Image

Am I doing this right? I'm a bit confused. Do the new o-rings just sorta sandwich between the compressor and manifold? It would kinda make sense but at the same time... it kinda doesn't.
1990 Isuzu Trooper 5MT - Pretty much stock all-around
furiousbob
Drives on Dirt
 
Posts: 72
Joined: Sun Feb 26, 2017 3:04 am
Location: San Gabriel, CA
Has thanked: 18 times
Have thanks: 2 times

Sponsor
 

Return to Audio & Electronics

Who is online

Users browsing this forum: No registered users and 1 guest